If you're new here, you may want to subscribe to my RSS feed. Thanks for visiting!

I have got water in my pressure washer pump oil. Im sure this means the seals are gone, but why isnt it leaking water out from between the head the the crankcase and onto the ground? But yet it can still push water into the crankcase? I dont understand that part. Do i have a problem other than the seals? The pressure is kinda low, 4000psi unit, 4gpm and only running 2300 psi or so with a 4.5 nozzle. Should be about 3500 i think with that nozzle. I did adjust the engine speed down a little but not too much. Pressure does build up to a little over 4000 psi according to the gauge when the trigger is released and the unloader goes to bypass mode. Please help!?